Just don't get it.,,,,,,,

[[JiF]BloodGod]

Hi guys, my problems with running crossfire on BF3 continue. Every time I Enable my crossfire on my Catalyst Control panel, Bf3 will black screen, if I disable it, it will run fine. I JUST DONT GET IT.....................UGH.



Any Ideas on this would be great......Thanks Guys BG

[[JiF] General WarHawk]

I'm not as familiar with Crossfire, but I do believe you are experiencing a driver issue related to Crossfire and BF3. I prefer to just get one really hot card, rather than try to use two, or three cards in a machine.


What is your current power supply and motherboard? A cheapo MoBo can also cause lockup issues if your PSU is sufficient to run both cards.

[[JiF][AARP]Grimp]

You might PM Doc. He is running it with Crossfire I believe.

[[JiF]BloodGod]

I believe my PS and MOBO should handle it, but I could be wrong, here they are-

MOBO-ASUS Saberthooth P67 ( B3 Revision )
PS-PC Power-Cooling 750w Silencer Mk11 ( Silver )

[[JiF]Doc]

Could you tell me your driver version? And Catalyst version? You can find this by opening the catalyst control center. First select advanced view under preferences, then go down to the information tab, and select software information.

[[JiF]BloodGod]

I'm running the 12.8

[[JiF]Doc]

Have you installed any of the Catalyst Application Profiles (CAP)?

[[JiF]BloodGod]

Well I guess I had a bad install, because I uninstalled it all, and reinstalled it and now it works fine.


Thanks for the help Doc.

[[JiF]zougathefist]

The problem may be Catalyst - I had a machine that only had one good card and whenever I used Catalyst to adjust the settings it would crash.

[[JiF]BloodGod]

I think you might be right, Zouga it stopped working again...............UGH